Can I Use Vinyl Lettering On Exterior Latex Painted Wood

If it has a rough surface make sure to sand it down the smoother the wood the better your vinyl will stick.

Can i use vinyl lettering on exterior latex painted wood.

The same goes for painting interior walls with regular emulsions and should be part of your preparation process not left until after the job is complete. Using a dark color on light vinyl can cause it to buckle and warp in direct sunlight. In that case vinyl trim can be painted using latex paint. In most cases installing vinyl trim means no painting and little maintenance but occasionally vinyl fades or a homeowner wants to change the color.

If it s been painted or sealed allow a few weeks for the paint or sealant to cure before applying vinyl. White siding may be painted light pastel shades. The rule of thumb when painting exterior vinyl is to paint it no darker than the original color. They are individually cut thin self adhesive and can be applied to most any smooth non porous surface.

I m using this 12 x 6 wood board that came pre hung with a rope but you can use any board that has a flat surface. If your sign is originally raw wood you ll want to paint it. Here s how to use vinyl on painted wood. If you have a choice of paint use 1shot or an enamel paint.

So for this vinyl stencil technique you re going to need some permanent adhesive vinyl in any color matte mod podge don t use glossy acrylic paint and a wood board. Then make sure there s no sawdust or residue on the wood before applying the vinyl. The number one risk factor in using outdoor paints is lack of ventilation. Unlike other paints latex will expand and contract with the vinyl preventing cracks and peeling.

If your vinyl surface is clean the paint or primer will adhere to the vinyl rather than the dirt and you will have a longer lasting finish. If the vinyl letters are coming up. I think it s because i used really smooth wood and it s hard to capture on camera but if you d like a more painted on look using htv with heat is the way to go. Paint will not stick to a dirty surface.

You can think of vinyl lettering and graphics as a special type of sticker. They are literally paper thin approximately 3 mm about the thickness of 3 coats of latex paint. Try a vinyl with a solvent adhesive. Apply the 651 vinyl as usual and then with a teflon sheet between your project and iron iron the decal for 10 15 seconds.

Then paint with at least two coats. Be sure your vinyl is clean before applying paint by washing it with soap and water and rinsing well. My best advice is to start with the smoothest piece of wood you can find. Make sure your area is properly ventilated.